How to install barn door hardware?

Sliding Barn Door Hardware

If you're buying barn door accessories for the first time and don't know where to start to get it installed successfully, then with this article, you'll be a pro.

 ①Fix the steel hanger to the door: Drill holes in the top of the door and insert the hanger bolts from the back of the door (i.e. the hanger and acorn nut are attached to the front of the door). Attach the hanger with hanger bolts, washers and acorn nuts as shown below.

②Install the anti-jump pad: the screw is located near the front edge of the door (do not over-tighten it).

③ Connect the track and install the door stop: Loosely install the door stop near each end of the track (Final positioning will be determined at the end of installation).

④Draw a line for the track: Use a spirit level to draw a line to install the track,

⑤Marking and drilling: Arrange a track on the line and mark the position of the hole. (Align with wall studs if possible).

⑥Installing the track: Loosely connect one end of the track together and place the other end on the ground. Then swing the track up and connect the other end. Finally, fill the hole in the middle. Attach the track to the wall.

⑦Install the barn door: hang the steel coat hanger on the track, then twist the anti-jump pad towards the wall so that it is under the track.

⑧ Install the floor rails: place the door in the closed position you want, place half of the floor rails at the marked positions under the door, and fix the rails to the floor. Position the door in the desired closed and open positions and adjust the door stop.